Locksmith Brampton Latch Bolt Locks

Locksmith Brampton Latch Bolt Locks service is here for you to help with choosing and installing the right lock to your doors. Locksmith Brampton Latch Bolt Locks services are available 24/7, all days of the year. Call our Locksmith Brampton Latch Bolt Locks services, so our team can come to you and help.

Locksmith Brampton Latch Bolt Locks

Locksmith Brampton Latch Bolt Locks

 

Now, that you have chosen the latch bolt locks to be installed, we will guide you through the process, in case you would like to go ahead and do it yourself.

To begin the process of drilling holes, a few things have to be measured and marked on the door. First, locate where the handle should be placed on the door, and then mark of these points square around the door. The first hole that will be drilled into the door is the hole for the latch. It is important to find the center of the door edge that coincides with the points you marked across the door, so that you can drill through it with a spade bit. Measure the length of the backset of your lock, and mark the corresponding length on the head of the drill bit.  

Our professional locksmith will have the necessary tools to carry out this lock installation process and they will know just how to handle all the complicated steps. It is important to measure the length of the backset so that you do not drill too far back into the door.

Once the desired depth for the latch has been obtained, you will need to chisel out the proper shape, so that the lock can fit properly into the door. Chiseling out the desired shape is a pretty easy affair that involves tracing out the outline of the bolt, and then chiseling around the hole that was bored in with the spade bit. The same step is followed to chisel out the plate surrounding the bolt. After you have made the required holes for the depth of the latch you will need to drill the holes that allow you to set up the levers/knobs on both sides of the door. This is done differently depending on which type of door handle you decide to go with. For instance, for door knobs, you will need to drill a hole that corresponds to the size of the faceplate of the knob so that it fits in there perfectly, whereas, with the lever locks, you merely need to drill a small hole that allows the spindle to pass through from one side to the other.

After the holes have been drilled and the spindle has been passed through the lock, the next step involves screwing the interior and exterior sections of the lock into the door.

This completes one part of the lock installation process. The strike for the lock needs to be made next. The process of cutting out the strike is similar to the steps that were outlined above. The throw of the bolt needs to be measured out, and that corresponding length needs to be drilled into the doorframe. Keep in mind that the strike needs to be on the same level as the latch bolt lock that was inserted into the door. This is to ensure that once the door closes the latch will be resting flush within the strike.

Call Locksmith Brampton to help you install any lock  – we are on call 24/7 – call us now!